hull (volume hatch, BSID 500)
core hatch (BSID 510)
powder, not yet melted
border
Why split the volume?
The surface region decides how accurate and dense the visible part is. The inside is hidden; it only has to
be solid. The core can therefore get more productive settings: by default 350 W at 1300 mm/s with 0.12 mm
hatch distance, against 280 W, 1200 mm/s and 0.1 mm for the hull. With 30 µm layers that is about
75 J/mm³ in the core and 78 J/mm³ in the hull.
Core every n-th layer
With Expose core every n-th layer set to 2 the core is skipped on one layer and exposed on the next.
The powder of the skipped layer stays loose until the core laser melts both layers at once. The hull keeps
the fine layers, so the surface does not change. In the section on the left you see the core slabs
become n layers thick; press Build up to watch it layer by layer.
The laser settings of the core do not change with n. Melting two layers with the same power and speed puts
only half the energy into each cubic millimetre (about 37 instead of 75 J/mm³), so a core layer skip
usually goes together with more core power or a smaller core hatch distance.
The section shows 12 layers of 0.5 mm instead of the 200 layers of 30 µm of the demo cylinder,
and the hatch spacing is exaggerated. The cylinder size and the hull thickness are real millimetres. The
demo build exposes the core on the layers whose number is a multiple of n (z 3.00 and 3.06 mm, not 3.03 and
3.09 mm, for n = 2); the drawing follows the same rule.
Parameters
| Parameter | Default | Meaning |
| Hull and core | off | Switches the split on. |
| Hull thickness | 1.0 mm (0.05–100) | Minimum wall thickness of the hull. |
| Expose core every n-th layer | 1 (1–10) | 1 = every layer; n = the core melts n layers at once. |
| Core hatching (Hatching) | 0.12 mm | Own hatch group of the core: pattern, distance, rotation. |
Laser settings (group Scanning)
| Vector type | BSID | Power | Speed |
| Volume hatch (hull) | 500 | 280 W | 1200 mm/s |
| Core hatch | 510 | 350 W | 1300 mm/s |
In the code
Follow the parameters from the dialog to the laser in How the code works, and
change the defaults yourself with the recipes below.